What Size SuperSlide II?

We want to make sure you get the right SuperSlide II for your RV. This means making sure that the slide you buy fits properly. While the general guideline of buying a trim kit for your slide 4" narrower than the compartment's door frame is valid, there are additional factors that need to be considered.

Obstacles on the compartment walls — The actual width of your SuperSlide II is dependent on the distance between the two narrowest points which will interfere with the pull action of the tray. If there are obstacles on the walls of your compartment less than 6" from the floor, you will need to measure from the narrowest point.

Compartment lip and SuperSlide II height — The SuperSlide II pulls out 1.39" above the floor of the compartment. You must make sure the lip of your compartment is lower than this or you will need to raise your slide as indicated in the Installation Instructions. Your SuperSlide II has a height of a little over 6". You must make sure that the slide will fit in between or under all wall fixtures before installing.

 


This dimensional drawing of the face of the SuperSlide II illustrates the need for adequate clearance on the sides to a height of at least 6.11".
(Part No. shown is 905849024)

Remember
  • It is recommended that the trim kit be 4" narrower than the compartment opening.
  • If the lip of your compartment is taller than 1.4", you will need to raise the slide as directed in the Installation Instructions.
  • The SuperSlide II has a height of a little more than 6".
  • You will need to supply any wood required for flooring or raising the slide to accommodate the lip of the door frame.
  • Make the most of your SuperSlide II by adding our Stow & Go Storage Solutions to your tray and garage.

See other cargo slides:
Heavy Duty Slide
Super Slide
And Utility Tray slides:
Utility Trays